TTORA Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
212 Posts
Discussion Starter #1
I'm getting ready to order some degree shims from 4crawler. My leaf spring is 2-3/8" wide. Will their standard 2" wide shims be ok, or do I need to get custom 2-3/8" wide shims?

And the standard size for center bolts should be 3/8" dia. right? I don't have time this week to remove the u-bolts and pinion snubber to measure. I have the OME Dakar leaf springs.
 

·
Registered
Joined
·
251 Posts
The 2" width is fine. I installed my set from 4crawler yesterday (well one of them anyway). I'll be finishing up tonight. I didn't measure my center pin diameter but just tell Roger what its for and he'll take care of the rest. The diameter he drilled in my shims is perfect and 3/8" sounds about right.
 

·
Registered
Joined
·
212 Posts
Discussion Starter #4
Chargedtaco01 said:
The 2" width is fine. I installed my set from 4crawler yesterday (well one of them anyway). I'll be finishing up tonight. I didn't measure my center pin diameter but just tell Roger what its for and he'll take care of the rest. The diameter he drilled in my shims is perfect and 3/8" sounds about right.
thanks :thumbs:
 
1 - 4 of 4 Posts
Top