TTORA Forum banner

Write up for gear oil swap?

2074 Views 6 Replies 6 Participants Last post by  platform389
Any writes up on how to do this? This will be my first attempt at this procedure... any input is appreciated.

I am swaping out

- man tranny
- T-case
- and both diffs (that is correct isn't it, I know you are suposed to do the rear but I am not sure about the front)

Any idea how much gear oil I will need? I figure I will be safe if I buy 12 quarts.
1 - 1 of 7 Posts
You'll need a 24 mm socket, preferably a 6 point, and a breaker bar is nice too but do NOT re-tighten the plugs with the bar, use a torque wrench. I can't remember what size the socket head plugs are on the front diff but like someone said, they are in there very tight. Take the fill plug out first to see if it will even come out, so you don't drain all your fluid and end up not being able to put it back in, which would suck. The differential drain plugs have magnets, clean 'em off. Don't get the gear oil on you or you will stink something fierce.
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.